|on an angle to shoe 3d highlights|
where anything goes. The image I chose is Garden-Sprite-GiGGles by artist Rick St. Dennis.
All my cards are 3D so I printed the image three times and I colored them with
Prismacolor Pencils. Then I cut the images in different places and stack them together
with soft pads to form a 3d image.
I took a piece of chip board 7 1/2" X 9" and covered the front and back with card
stock to make a plaque.Then, I adhered my 3D image on various card stock one of
which is by Digi Paper Design by Lozzy.
My final act was to embellish the card with ribbon, flowers, buttons and a sentiment.
I hope this project inspired you to join our challenge at A Bit More Time To Craft.
Thank you for visiting please come again.